|
 Vanes are supplied in interlocking pairs, the paired vanes having five and six knuckles respectively. Vanes are separated with belled washers and overlapped spindle ends are connected to brackets.
When the spindle has been cut to a shorter length, it should be drilled and a nut an bolt fitted as a retainer. This arrangement ensures continuity of the barrier at corners.
Brackets are available for fitting to fences and wall copings - special brackets are available to order.
How to order
When ordering please state metre run required. If not a straight run or runs, specify other details such as corners etc.
To calculate components required, use the formula below:
Divide Length of run by 1.283 - this will give the number of axles
Round figure up or down to give the No. of complete axles
Axles x 4 = No. of Vanes (pairs)
Vanes x 2 = No. of Belled Washers
Axles + 1 = No. of Standard Brackets and Top Pivots
 Bolt threads may be welded or deformed after erection to prevent removal.
Double and treble stacked barrier and double width available to order.
| Parts List |
|
|
492251 |
Expanded steel vanes in interlocking pairs, four pairs required per spindle |
|
492253 |
Spindles, length 1.32m |
|
492254 |
Spindles, washer welded at one end, length 1.32m |
|
492257 |
Top pivot |
|
492256 |
Standard brackets |
|
492259 |
Coping stone brackets |
|
492252 |
Belled washers, two for each set of vanes |
|
4922510 |
Pipe Guard Fitting |
|
